An engine sound for any electric car
Brul is a web app that gives an electric car the engine it never had: a synthesized V8, V12, flat-six or rotary that follows your right foot and plays through the car’s own speakers. It runs on your phone over Bluetooth or a cable in any EV or plug-in hybrid that plays your phone’s audio, and straight in the browser of a Tesla.

Why are electric cars so quiet?
An electric motor burns nothing. There are no cylinders firing, no exhaust pulses and, in most EVs, no gear changes, so most of what you hear is the tyres, the wind and a faint electric whine. Plenty of drivers love that calm. Others miss the sound that told them how hard they were pushing.
A few new performance EVs come with a synthetic engine sound of their own. Most don’t, and aftermarket sound kits have to be bought and fitted. Brul does it with the phone you already carry and the speakers already in your car.
Plug-in hybrids are just as quiet in electric mode, and Brul works the same way there. When the combustion engine starts, Brul simply plays on top of it, like music.
What does Brul add to an EV?
It follows your right foot
In an EV, acceleration tracks the pedal almost instantly. Your phone’s motion sensors measure it within a few tens of milliseconds, and Brul turns that, plus air resistance, into engine load. Uphill works too, because the sensor feels the slope.
A gearbox you can hear
Behind the sound sits a virtual seven-speed gearbox. Road speed decides the revs, each upshift briefly cuts the ignition and downshifts get a throttle blip; Comfort, Sport or Track decides how late it shifts.
Regen becomes engine braking
Lift off and regenerative braking turns into an engine on overrun. Up to 0.4 m/s² of slowing beyond normal rolling and air resistance counts as coasting; past that, after 0.3 seconds, the engine brakes until you’re back on the throttle or the slowing is over.
Pops when you want them
With Brul Pro: pops and bangs on hard upshifts, on downshifts and after lifting off at high revs. Never in Comfort, subtle in Sport (full if you switch them on), always in Track.
How do you add engine sound to an electric car?
Brul doesn’t connect to your car’s systems, so it works in cars like the Volkswagen ID. models, Hyundai Ioniq, Kia EV models, Polestar, BMW i, Mercedes EQ, BYD and MG: anything that can play your phone’s audio. Brul is not affiliated with any of these makers. Driving a Tesla? Brul also runs in the car’s browser, no phone needed.
- Pair your phone with the car over Bluetooth or plug in a cable, as you would for music, and open brul.app.
- Choose Drive. Under Your car, pick your car; tap Electric to see only the electric ones, from a Fiat 500e or an MG4 to a Hyundai Ioniq 5 N or a Porsche Taycan. Brul uses its weight, power and top speed to work out throttle and shifting. Not listed? Under Car not listed?, enter its make, model and top speed, choose Electric under Fuel and add its power if you know it, and Brul works out the rest. Then pick an engine.
- Mount the phone so it can’t move, tap Start and allow motion and location. Stand still: calibration starts by itself. Then pull away straight with firm throttle. You only do this once per holder.
- Drive, and don’t touch the phone again until you’ve parked.
App or hardware sound generator?
Active sound kits and fitted sound generators exist for many EVs. They do a different job, so here is a straight comparison.
| Brul | Hardware sound generator | |
|---|---|---|
| Price | €9.99 once | Typically €1,000 or more |
| Installation | None: a phone in a holder | Has to be fitted to the car |
| Where you hear it | Inside, through the car’s own speakers | Depends on the kit; some play outside the car |
| Sounds | 13 engines, 3 drive modes, 3 exhaust settings (with Brul Pro) | Depends on the kit |
| Next car | Open brul.app in it | Stays in the car it was fitted to |
| Works without a phone | Only in a Tesla, in the car’s browser | Yes |
Hardware prices as seen at retailers in October 2026; they vary by kit and car. If you want people outside to hear your car, an app is the wrong tool: Brul is for the people inside, and sound devices that play outside the car are restricted in some countries.
AVAS or engine sound: what’s the difference?
AVAS (Acoustic Vehicle Alerting System) is the warning sound an electric or hybrid car plays outside at low speed, so pedestrians and cyclists hear it coming. New electric and hybrid cars must have one in the EU, the US and other markets; in the EU it sounds from standstill up to about 20 km/h and when reversing.
Brul is something else: entertainment for the people in the cabin, played through the same speakers as your music. It has no connection to the car, so it does not replace, change or switch off the AVAS, and it isn’t meant to warn anyone outside.
Treat it like music: keep the volume low enough to hear traffic and sirens, and don’t operate your phone while you drive.
What could your EV sound like?
Every button plays a clip straight from Brul: the engine starts, pulls through the gears at full throttle and lifts off. The flat-plane V8 fires like two four-cylinders on one crankshaft, each bank evenly, and shrieks to 9,000 rpm; the five-cylinder turbo warbles; the flat-six wails to 9,000; the race V10, modelled on a 2000s Formula 1 engine, idles at 4,500 rpm and screams to 19,000.
Every engine, free to try
Mount your phone, connect it the way you play music and open brul.app. Try it free now, with every engine unlocked.
Try it in your EVQuestions
Does Brul work in any electric car?
Yes. Brul doesn’t connect to the car’s systems, it only reads your phone’s sensors, so the make doesn’t matter: if the EV plays music from your phone, it plays Brul. In a Tesla, Brul can also run in the car’s own browser with no phone at all.
Does it work in a hybrid or plug-in hybrid?
Yes. It sounds best in electric mode; when the combustion engine runs, Brul plays over it like music and mixes with it.
Is it legal to play an engine sound in my car?
Brul is not a vehicle modification or an exterior sound generator: it plays inside the car, through the speakers your music uses, and changes nothing on the car. As with music, keep the volume low enough to hear traffic and sirens and follow local rules. This is not legal advice.
Does Brul replace or switch off my car’s pedestrian warning sound?
No. The AVAS is part of the car and plays outside. Brul plays inside and has no connection to the car, so the AVAS keeps working exactly as before.
Does it work with one-pedal driving?
Yes. Brul doesn’t read the pedal but how the car speeds up and slows down, so strong regen in one-pedal mode comes through as engine braking, while a gentle lift sounds like coasting.
Do I need an OBD adapter or a connection to the car?
No. Brul gets your throttle from your phone’s motion sensors after a one-time calibration, and your speed from GPS. There is no adapter, no wiring and no app to install.
Is it a recording?
No. Brul synthesizes the sound live, cylinder by cylinder: each exhaust pulse runs through a modelled manifold, exhaust and muffler, then through an exhaust impulse response. That is why it follows your throttle smoothly instead of looping a clip.
What does it cost?
Trying is free: 5 minutes with every engine and feature in Simulation and a 10-minute test drive in Drive. After that, Brul Pro is €9.99 once ($9.99 / £9.99): no subscription, no account, up to 5 devices.